back when i showed a
sneak peek... a few people guessed this was a tree skirt... and it could be... but mine is a hot pad topper...
my inspiration came from this print in the figgy pudding line of fabric by basic grey for moda
i loved it and wanted a big sugar swirl!
Supplies
Easy Dresden Ruler
1/2 yd white print
10 scraps of other colors
5/8yd backing fabric
batting {at least 19" square}
silver teflon fabric {at least 19" square}
scrap of fusible web
1. use the easy dresden ruler to cut 10 white wedges and 10 assorted wedges from scraps. Cut them at the full 8" size.
2. piece them into a circle making sure you place a white wedge in between each color. press to the dark fabrics.
3. find a scrap of batting that is large enough...
4. and trim around leaving about 1/2" or so.
5. repeat with backing fabric.
6. and lastly with the silver teflon fabric... it feels more like plastic and is available at most shops & chain stores.. it is often used to make ironing board covers and pot holders.
7. now its time to layer. start with the silver teflon fabric shiny side down, then batting, then backing fabric right side up... and lastly your sugar swirl right side down.
8. put lots of pins in... and sew a giant circle all the way around about 1/4" in from the edge of your sugar swirl. since the ends of your dresden template are straight you'll need to sew a gentle curve or you'll end up with 20 straight little sides instead of a circle. {i looked it up and its a called an Icosagon}
9. anyway back to the project... trim all around your sugar swirl removing excess batting, backing and teflon.
10. now for the magic... use the opening in the center to turn your sugar swirl right side out.. voila!
11. press your sugar swirl into a neat circle and put pins in the dark sections. using a walking foot quilt straight lines from one end to another in the middle of the white areas. {do this a total of 5 times}
12. this should be your result.
13. now we need to cover up the hole in the middle... i used a CD as my template and traced it on a piece of fusible web. iron it on the white fabric and cut it out.
14. place it in the center on top of the silver teflon fabric and iron in place.
15. sew a zig zag stitch around the entire circle. I did a wide zig zag that was close together... but not as tight as a satin stitch. {my machine was at 4 for a width and 1.5 for a length}
16. you should end up with it looking like this.
and your done!!!
notes:
1. this also works as a candle mat... with or without the silver teflon fabric
2. if you are going to use this for really hot things... it can't hurt to use 2 layers of silver teflon fabric and 2 layers of batting.
3. to make this a mini tree shirt... sew all the wedges together except for the last seam. trim 1/2" off of each of these pieces. {where the seam would have been} repeat remainder of steps... but in step 8 sew around the outside.. down one straight wedge.. around the inner ring and back up the other straight side.. leaving an opening to turn somewhere.... you won't need to make a center because that is where the tree will be!
--
want to link to this tutorial?
grab a button!
{144 x 144}
{250x250}
enjoy!!
© 2009-2022 Julie R. Herman. All rights reserved.
No part of this tutorial or pattern may be reproduced without written consent of Jaybird Quilts.
Items from this pattern may not be produced for commercial resale.